Descargar Imprimir esta página

Brother DB3-B775 Manual De Instrucciones página 106

Ocultar thumbs Ver también para DB3-B775:

Publicidad

10. INSTALLING OPTIONAL PARTS
. Install the speed controller @ to the air blow assembly ©. install the air blow assembly @ to the air blow setting
plate @ with the nut 6. Install the air blow setting plate @ to the presser bracket ® with the screw (bind SM3.57-40
x 6).
. Pass the air tube (inside diameter 4 mm) @ through the work table hole, and then connect it to the air blow connect-
ing rod @ and the speed controller €.
7. Secure the air tubes @ and O to the underside of the work table with the 6N cord holder @ and the screw (M3.1 x
13) ® so that they do not touch the V-belt.
8. Remove the cord holder (B and the screw ® which are attached to the machine head, and secure the air tube © in
the position shown in the illustration.
9. Secure the three air tubes in the position shown in the illustration with the 5N cord holder ® and the screw (SM3.57-
eo
40 x 6) ®.
10. Turn on the air.
11.
85
Use the adjustment screw of the speed controller €) to adjust the air blow operation.
DB3-B775, B776

Publicidad

loading

Este manual también es adecuado para:

Db3-b776