Installation Instructions - John Bean QUADRIGA 1000 Manual Del Operador

24
Introduction
STORE THIS MANUAL IN A SAFE PLACE FOR
ANY FURTHER REFERENCE. READ THIS
MANUAL THOROUGHLY BEFORE USING
THE MACHINE.
Application
The tire changer is intended to be used as a device
for automatically demounting, mounting and beading
motor vehicle, SUV and light truck tires mounted on
one-piece rims with the following specifi cations:
Maximum wheel diam.:
Maximum wheel width:
Minimum wheel centre bore:
This device must be used in the application for which
it is specifi cally designed. Any other use shall be
considered as improper and thus not unreasonable.
The manufacturer shall not be considered liable
for possible damage caused by improper, wrong or
unreasonable use, such as working in Manual Mode.
Manuals supplied with the unit
• Operator's Manual
(Chapter 1 – 9)
The operator must be familiar with it.
• Spare Parts Booklet
(Spare Part Table and List)
This document is for service personnel use only.
• Accessory Plan.

Installation instructions

The installation instructions are in Chapter 9,
Appendices.
Operator's Manual
1200 mm (47")
432 mm (17")
40 mm
QUADRIGA 1000/BB