Key Automation ALT3KF Instrucciones Y Advertencias Para Su Instalación Y Uso página 39

6 - CONTROL UNIT
6.1 - Description of the control unit
The CT10324 and CT10324F control unit is the most modern,
efficient system for the control of Key Automation motors for the bar-
riers. All other, improper, use of the control unit is forbidden.
1
M +
M -
V+
22
ENC
NEG
12
6.2 - Description of the connections
1- Motor power supply (M+ and M-)
2- Transformer power supply connector
3- Connection of flash light, courtesy light, barrier open indicator
light/electic lock
4- 24 Vac connector for control and safety devices
5- 24 Vdc unregolated for safety device (photocell and radio edge)
6- Safety input connectior for STOP or edge and photocell
7- Connector for control devices
8- EDGE/STOP, PH2, PH1 safety red LED; OPEN, CLOSE, PAR,
SBS input green LED
9- Safety override dip switch
10- Limit switch connector
11- Limit switch red LED indicators
6.3 - Models and technical characteristics
CODE DESCRIPTION
CT10324F 24V control unit for ALT3KF barrier motor
CT10324 24V control unit for ALT4Kand ALT6K barrier motor
- Power supply with protection against short-circuits inside the con
trol unit, on motors and on the connected accessories.
- Obstacle detection.
- Automatic learning of working times.
21
13
POWER
SUPPLY
2 3
The CT10324 and CT10324F has a display with 5 digit and 14 seg-
ments that allow easy programming and constant monitoring of the
imput status; the menu structure also allows easy setting of the wor-
king times and operating modes.
10
19
14
17
11
15
9
16
8
ON
STOP PH2 PH1 OPEN CLOSE PAR
4 5 6 7
12- Connector for battery charger KBP/KBPN
13- Fuse 1.6 AT time lag
14- Function display 5 digit 14 segment
15- STEPPING SBS button ( )
16- UP ( ) button
17- MENU ( ) button
18- DOWN ( ) button
19- KEY LED indicator
20- Antenna
21- SBK: predisposition for energy saving module when control
unit is not active (optional)
22- Encoder connection
23- Connector for KUBE interface / PowerBus (optional)
- Safety device deactivation by means of dip switches: there is no
need to bridge the terminals of safety devices which are not instal
led - the function is simply disabled by means of a dip switch.
ANT
SHIELD
20
18
23
SBS
EN
39