Key Automation ALT3KF Instrucciones Y Advertencias Para Su Instalación Y Uso página 51

10
11
12
13
14
15
16
17
18
Hold-to-run
de.a.
0 = off
1 = on
This parameter determines the behavior of the
red and green lights of the barrier
5 = MODE1
• Red light on if closed
• If open, all the LEDs are off
• Flashing green light during opening
• Flashing red light during closure
• Barrier stopped but not on the limit switches
flashing
IN.D.
red light
6 = MODE2
• Red light on if closed
• If open, steady green light
• Flashing green light during opening
• Flashing red light during closure
• Barrier stopped but not on the limit switches
flashing
red light
se.r.
Service interval cycle threshold (0 = off)
Enabling of continuous flashing indicating service
required with
se.f.
barrier closed)
0 = off
1 = on
Set to 0 if the old CTLIGHT2 module is used.
Electric lock activation time (in seconds), if
FLASH SETUP=3
EL.T.
Magnetic lock deactivation time if FLASH
SETUP=4
High-speed motor start-up
ST.P.
0 = off
1 = on
1 = Off (use of virtual encoder)
En.C.
2 = On (use of motor's physical encoder)
DE.F.
2= Factory setting restore for ALT3KF barrier
≠ 0 (only active with
0 0 1
6 5 6
10 0 200
0 0 1
1 0 1
4 1 10
0 0 1
1 1 1
1 1 1
EN
x 1000
cycles
s
51