Descargar Imprimir esta página

Key Automation ALT3KF Instrucciones Y Advertencias Para Su Instalación Y Uso página 54

Automatización para barreras viales con mástil desde 3 hasta 8 m

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
EN
correct, adjusting the bar end stops if required (see paragraph
5.4 "Adjustment of the bar angle") and, if necessary, carry out
the self-learning procedure for the travel and main operating
parameter values once again (see paragraph 6.6 "Travel self-
learning").
17. Check, one by one, all the safety devices present in the system
(photocells, sensitive edges, emergency buttons, etc.) to ensure
their efficiency. Make sure that the photocells are securely fixed
to their supports and check the integrity of the lids/lenses. Tho-
roughly clean their front surface (do not use solvents).
18. Check the efficiency of the LED flashing lights integrated in the
9.2 - Scheduled replacements
The components that make up the ALTK automation system have
been designed to last, under normal conditions of use, for the entire
working life of the product without any special action being required.
However, some of them are directly linked to system safety and the-
refore, it is recommended to regularly replace them according to the
following indications:
1. Replace the balancing spring(s) every 2 years or every 200,000
opening/closing cycles
2. Replace: - the aluminium bar AST3F, ASTL4, ASTL4J, ASTL6,
ASTL6J every 5 years or every 500,000 opening/closing cycles
- the aluminium bar AST3F, ASTL5, ASTL8, ASTL6J every 3 years or
every 250,000 opening/closing cycles
- the articulated bar AS-SNO3 every 2 years or every 150,000
opening/closing cycles
3. Replace the gearmotor every 5 years or every 500,000 opening/
closing cycles
54
barrier body and the integrity of the transparent covers.
19. Check the integrity and efficiency of any accessories installed:
APM mobile support, APFX fixed support, SKIRT2 racks, joint
for articulated bar, etc. Make sure that they are firmly secured.
20. Check that the automation system is working properly and that
the bar motion is smooth. Ensure that the opening and closing
speeds are adequate for the length of the bar, with gradual acce-
leration in the initial phase and progressive slowing down in the
final phase of the travel, in order to avoid dangerous jolts and
swaying that could affect the safety and life of the bar.
21. Ensure compliance with the regulation provisions, in particular
the requirements relating to user safety contained in the EN
12453 standard (see paragraph 8.1 "Testing")

Publicidad

loading

Este manual también es adecuado para:

Alt4kAlt6k900alt3kf900alt4k900alt6k