Publicidad
Idiomas disponibles
Idiomas disponibles
Pre start-up inspection
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is rst. Please refer to the service section for detailed guidance. If any fault is discovered, the compactor must not be used until
the fault is recti ed.
1. Thoroughly inspect the compactor for signs of damage. Check components are present and secure. Pay special attention to the
belt guard.
2. Check the engine oil and hydraulic oil level and top up as necessary.
3. Check the engine fuel level and top up as necessary.
4. Check for fuel, oil and hydraulic leaks.
WARNING
Honda GX390 Petrol Engine
1.
Open the fuel tap by moving the fuel ON / OFF lever fully to the right.
2.
If starting the engine from cold, set the choke ON by moving the choke lever fully
to the left. If restarting a warm engine, the choke is usually not required, however, if
the engine has cooled to a degree, partial choke may be required.
3.
Turn the engine ON / OFF switch clockwise to the 'I' position.
4.
Set the throttle to the idle position by moving the throttle lever fully to the right. Do
not start the engine on full throttle, as the compactor will vibrate as soon as the
engine starts.
5.
Taking a rm hold of the control handle with one hand, grasp the recoil starter
handle with the other. Pull the recoil starter until engine resistance is felt, then let
starter return.
6.
Taking care not to pull the starter's rope fully out, pull the starter handle briskly.
7.
Repeat until the engine res.
8.
Once the engine res gradually set the choke lever to the OFF position by moving it to the right.
9.
If the engine fails to re after several attempts, follow the troubleshooting guide.
10. To stop the engine, set the throttle to idle and turn the engine ON / OFF switch anticlockwise to the '0' position.
11. Turn the fuel off.
Hatz Diesel Engine (Crank Handle)
1. If possible, disengage the engine from any driven equipment. The auxiliary equipment should always be placed in neutral.
2. Set speed control lever to a position between START and max. START, according to requirements, Selecting a lower engine will
reduce speed when starting.
3. Make sure that the stop lever, if tted, is in the operating position.
4. Turn decompression lever until stop is reached. In this position automatic decompression is heard to engage and the engine can
then be started.
5. After the automatic decompression device has engaged at its stop limit, 5 turns of the handle are needed for the engine to build up
compression and re again.
6. Take hold of the starting handle with both hands and turn it at increasing speed. The maximum speed of rotation must have been
reached by the time the decompression lever has returned to the '0' position. As soon as the engine has started, pull the starting
handle out of the guide sleeve.
7. If the engine back res because the handle was not turned rmly enough, release the crank handle immediately and stop the
engine.
8. To restart the engine, wait until it has come to a standstill, then repeat the starting preparations.
Pre-Start Checks
Start And Stop Procedure
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
9
GB
GB
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.
Publicidad
