Publicidad
Idiomas disponibles
Idiomas disponibles
Set Up VFO Frequency
Turn the radio to VFO mode, then press the [A/B] key to switch to the main band, accompanied by the MAIN icon display.
Operation 1: Input the VFO frequency directly by the keyboard.
▲/▼
Operation 2: Press the
For example, to input a frequency of 144.97500, enter [1] [4] [4] [9] [7] [5] in sequence, and the screen will display 144.97500 VFO
Step frequency setting path: Press [MENU] + [1] to enter step frequency>>Set step frequency 2.5/5.0/6.25/10.0/12.5/220.0/25.0/50.0/100KHz.
Selecting a Channel
A channel is a group of radio characteristics, such as transmit/ receive frequency pairs.
Press [VFO/MR] key to switch the radio between VFO and Channel mode, select Channel mode.
▲/▼
Operation 1: Press the
Operation 2: Input the channel numbers by the keyboard. For example, if you want switch to channel 99, input 0+9+9 a total of 3 digits, and it
will switch to channel 99.
Making a call
• Channel mode call
After selecting a channel, press and hold the [PTT] key to initiate a call to the current channel. Speak into the microphone with normal tone.
Making a call, the red LED is on.
• Frequency mode call
Press [VFO/MR] key to switch to the frequency mode, input the working frequency within the allowable frequency range, press and hold the
[PTT] key to transmit on the current frequency. Speak into the microphone with normal tone. Making a call, the red LED is on.
• Receive a call
When you release the [PTT] key, you can answer it without any action.
When receiving a call, the green LED is on.
NOTE: To ensure the best reception volume, keep the distance between the microphone and the mouth at the time of transmission from 2.5
cm to 5 cm.
Monitor
In standby, press and hold the [SK2] key to enter Monitor. When receiving matched carrier but the signaling or the signal is too weak, this
function allows monitor the weak signal.
key to adjust the VFO frequency steps.
key to select a channel.
Publicidad
