Baofeng UV-5RM PLUS Manual De Instrucciones página 25

RPT-RL
35 - Delay the squelch tail
of repeater
36 ROGER - Roger Beep
37 TONE-Tone-burst
38 MENU EXIT TIME
39 VOX DELAY
POWER ON MSG
40
- Power On Message
VOICEPRI - Frequency
41
hopping system
RESET
42
- Restore defaults
POWER ON PWD
43
-Power on password
44 STOP WATCH
45 SCRAMBLE
VERSION
46
- Version information
OFF [0] | 1 - 10
OFF [0] | ON [1]
1000[0]|1450[1]|1750[2]|2100[3]
5 [0] 10[1] - 60[10] in 5 second steps (TIMEOUT-
5)/5=[n]
0.5 [0] 0.6[1] -2.0[15] in 0.1 second steps
(TIMEOUT-0.1)/0.1=[n]
LOGO[0]|VOLTAGE[1]
OFF [0] | ON [1]
VFO [0] | ALL [1]
OFF [0] | ON [1]
ON
OFF [0] | ON [1]
Delay the Tail Tone of Repeater (X100 milliseconds)
Sends an end-of-transmission tone to indicate to
other stations that the transmission has ended.
To send out a tone-burst; you simultaneously will press
a key while holding down the PTT. No further
configuration required using this feature.
The time setting for menu exit without menu
operation.
There's a brief delay between when you finish talking
and the radio returns to tx mode; this delay can be
adjusted.
Welcome message displayed immediately after startup.
The LOGO is programmed by the manager.
Activate the frequency hopping function to prevent
interference from outside the group
Resets the radio to factory defaults, with some
exceptions.
Activate the radio power-on password. You must
enter the correct password to turn on the radio. The
default startup password is 000000
Activate the stopwatch function. Press the [MENU] key
to start timing.
Scramble is a voice inversion function that enables
private communication by scramble voice signals. The
SCR icon is displayed when scramble is enabled.
Access hardware and firmware information for the
radio