Baofeng UV-5RM PLUS Manual De Instrucciones página 23

LANGUAGE
18
- Language selection
DTMFST
19
- DTMFST
S-CODE
20
- Signal Code
SC-REV
21 - Scanner
Resume Method
PTT-ID
22 - When to send the PTT-
ID
PTT-LT
23 - Signal code sending
delay
MDF-A
24 - Channel Mode A
Display
MDF-B
25 - Channel Mode B
Display
ENGLISH [0] | 中文 [1]
•OFF [0]: No DTMF Side Tones are heard
•DT-ST [1]: Side Tones are heard only from
manually keyed DTMF codes
•ANI-ST [2]: Side Tones are heard only from
automatically keyed DTMF codes
•DT+ANI [3]: All DTMF Side Tones are heard
1[0] | 2[1] | 3[2] | 4[3] | 5[4] | 6[5] | 7[6] | 8[9] | 9[8]
| 10[9] | 11[10] | 12[11] | 13[12] | 14[13] | 15[14]
•TO [0]: Time Operation - scanning will resume
after a fixed time has passed
•CO [1]: Carrier Operation - scanning will resume
after the signal disappears
•SE [2]: Search Operation - scanning will not
resume
•OFF [0]: No ID is sent
•BOT [1]: The selected S-CODE is sent at the
beginning
•EOT [2]: The selected S-CODE is sent at the
ending
•BOTH [3]: The selected S-CODE is sent at the
beginning and ending
0[0]｜100[1]｜200[2]｜400[3]｜
600[4]｜800[5]｜1000[6]
•CH [0]: Displays the channel number
•NAME [1]: Displays the channel name.
•FREQ [2]: Displays programmed Frequency
•CH [0]: Displays the channel number
•NAME [1]: Displays the channel name.
•FREQ [2]: Displays programmed Frequency
Set the language type of menu and prompt voice.
•ENGLISH: Display as an English menu with English
prompts for operation.
•Chinese: Display as a Chinese menu and prompt for
operation in Chinese.
Determines when DTMF Side Tones can be heard
from the transceiver speaker.
Selects 1 of 15 DTMF codes. The DTMF codes are
programmed with software and are up to 5 digits each.
Scanning Resume Method
When to Send PTT-ID Codes are sent during either
the beginning or ending of a transmission.
PTT-ID Delay (milliseconds)
[A] MR/Channel Mode Display Format
Note: Names must be entered using software.
[B] MR/Channel Mode Display Format
Note: Names must be entered using software.