Baofeng UV-5RM PLUS Manual De Instrucciones página 20

b) Use the numerical keypad to enter the numerical short-cut code.
(5) And just as in the previous section;
a) To confirm your selection, press [MENU] and it will save your setting and bring you back to the main menu.
b) To cancel your changes, press [EXIT] and it will reset that menu item and bring you out of the menu entirely.
(6) To exit out of the menu at any time, press the [EXIT] key.
(7) All further examples and procedures in this manual will use the numerical menu shortcuts.
Appendix A. – Trouble shooting guide
The radio doesn't switch on
Battery recharge doesn't last long
Reception led turns on but no sound heard
The keypad doesn't work
Reception of other group signal while transmitting
NOTE: If the above solutions cannot fix your problems, or you may have some other queries, please contact your dealer for more technical
support.
Problem
The battery may be exhausted. Recharge it.
Uncorrected installation.
The battery pack is over. Change it with a new one. Battery pack is not
completely charged.
Make sure the volume is not too low. Make sure to have the same
CTCSS and DCS codes of your group
Keypad lock function hasn't been enabled
Change another CTCSS/DCS for your group
Solution