Publicidad
Idiomas disponibles
Idiomas disponibles
(3) Press [MENU] [1] [2] [MENU] [1] [2] [3] [MENU] [EXIT]
(4) Input receiving frequency (e.g. 43255000)
(5) Press [MENU] [3] [0] [MENU] [1] [0] [MENU]
(6) Press [EXIT]
(7) Input transmission frequency (e.g. 437.55000)
(8) Press [MENU] [3] [0] [MENU] [1] [0] [MENU]
(9) Press [EXIT]
(10) Press the [VFO/MR] key to switch to channel mode, and the channel number on the right will reappear.
Example 2. Editing a simplex channel with analog sub tones (receiving and transmitting at the same frequency)
Example: Creating a new storage channel in channel 10
Receiving and transmitting frequency: 432.66250 (same frequency as TX-RX), transmitting sub tones of 123.0
The operation steps are as follows:
(1) Press the [EXIT] key to exit the function menu, press the [VFO/MR] key to switch to frequency mode, and VFO will be displayed on the right
side.
(2) Press [MENU] [3] [1] [MENU] [1] [0] [MENU] [EXIT]
(3) Press [MENU] [1] [2] [MENU] [1] [2] [3] [MENU] [EXIT]
(4) Input receiving frequency (e.g. 432.66250)
(5) Press [MENU] [3] [0] [MENU] [1] [0] [MENU]
(6) Press [EXIT]
(7) Press [EXIT]
(8) Press the [VFO/MR] key to switch to channel mode, and the channel number on the right will reappear.
Example 3. Repeater Programming
The following explanation assumes that you are aware of the transmission and reception frequencies used by the relay, and that you have the
right to use that frequency.
(1) Press the [EXIT] key to exit the function menu, press the [VFO/MR] key to switch to frequency mode, and VFO will be displayed on the right
side.
(2) Use the numeric keypad to input the transmission (reception) frequency of the relay.
(3) Press [MENU] [2] [9] to enter the frequency difference frequency, and use the numeric keypad to enter the specified frequency difference
frequency.
To emit simulated sub tones (such as CTCSS: 123.0)
Input receiving frequency
To enter channel storage (such as channel 10)
To return the received frequency added
To enter the same channel storage (such as channel 10)
To return the transmission frequency added
To delete the channel (using channel 10 as an example)
To emit simulated sub tones (such as CTCSS: 123.0)
Input receiving frequency
To enter channel storage (such as channel 10)
To return the received frequency added
To return to channel storage completed
Publicidad
