Baofeng UV-5RM PLUS Manual De Instrucciones página 19

Note: During frequency Search, press the
Main Menu Operations
For a complete reference on available menu items and parameters, see Appendix B, Menu definitions.
If your radio is set to Memory (MR) mode, the following menu items will not take any effect: STEP, TXP, W/N, CTCSS, DCS, S-CODE, PTT-ID,
BCL, SFT-D, OFFSET, MEM-CH.
Basic use
Using the menu with arrow keys
(1) Press the [MENU] key to enter the menu.
▲/▼
(2) Use the keys to navigate between menu items.
(3) Once you find the desired menu item, press [MENU] again to select that menu item.
▲/▼
(4) Use the keys to select the desired parameter.
(5) When you've selected the parameter you want to set for a given menu item;
a) To confirm your selection, press [MENU] and it will save your setting and bring you back to the main menu.
b) To cancel your changes, press [EXIT] and it will reset that menu item and bring you out of the menu entirely.
(6) To exit out of the menu at any time, press [EXIT] the key.
Using short-cuts
As you may have noticed if you looked at Appendix B, Menu definitions, every menu item has a numerical value associated with it. These
numbers can be used for direct access of any given menu item.
The menu is also organized in such a way that the ten most common functions are on top.
The parameters also have a number associated with them, see Appendix B, Menu definitions for details.
Using the menu with short-cuts
(1) Press the [MENU] key to enter the menu.
(2) Use the numerical keypad to enter the number of the menu item.
(3) To enter the menu item, press the [MENU] key.
(4) For entering the desired parameter you have two options:
a) Use the arrow keys as we did in the previous section; or
[Pound # ] key on the radio to switch between UHF or VHF bands.