Baofeng UV-5RM PLUS Manual De Instrucciones página 24

BCL
26
- Busy Channel Lock-out
AUTOLK – Automatic
27
Keypad Lock
SFT-D
28 - Frequency Shift
Direction
OFFSET - Frequency shift
29
amount
MEMCH - Store a
30
Memory Channel
DELCH - Delete a
31
memory channel
AL-MOD
32
- Alarm Mode
STE
33
- Squelch Tail Elimination
RP-STE - Squelch Tail
34
Elimination
OFF [0] | ON [1]
OFF [0] | 5 [1] | 10 [2] | 15 [3]
•OFF [0]: TX = RX (simplex)
•+ [1]: TX will be shifted higher in frequency than
RX
•- [2]: TX will be shifted lower in frequency than
RX
00.000 - 69.990 in 10 kHz steps
001 - 999
001 - 999
•SITE [0]: Sounds alarm through your radio
speaker only
•TONE[1]: Transmits a cycling tone over-the-air
•CODE [2]: Transmits '119' (911 in reverse)
followed by the ANI code over-the-air
OFF [0] | ON [1]
OFF [0] | 1 - 10
Disables the [PTT] key on a channel that is already in
use. The transceiver will sound a beep tone and will not
transmit if the [PTT] key is pressed when a channel is
already in use.
Set the automatic keyboard lock delay time. To prevent
the keyboard from being accidentally triggered.
When turned on, if the keyboard is not used within a
predetermined delay time, the keyboard will be locked.
Pressing the [Star *] key for 2 seconds will unlock the
keypad.
Enables access of repeaters in VFO/Frequency Mode
Specifies the difference between the TX and RX
frequencies
This menu is used to either create new or modify
existing channels (001 through 999) so that they can be
accessed from MR/Channel Mode.
This menu is used to delete the programmed
information from the specified channel (001 through
999) so that it can either be programmed again or be
left empty.
•SITE: Sounds alarm through your radio speaker only
•TONE: Transmits a cycling tone over-the air
•CODE: Transmits '119' (911 in reverse?) followed by
the ANI code over-the-air
This function is used eliminate squelch tail noise
between BaoFeng handhelds that are communicating
directly (no repeater).
Reception of a 55 Hz or 134.4 Hz tone burst mutes the
audio long enough to prevent hearing any squelch tail
noise.
This function is used eliminate squelch tail noise when
communicating through a repeater.