Baofeng UV-5RM PLUS Manual De Instrucciones página 22

TOT- Transmission Time-
9
out-Timer
R-CTCS
10
- Receiver CTCSS
R-DCS
11
- Receiver DCS
T-CTCS
12
- Transmitter CTCSS
T-DCS
13
-Transmitter DCS
14 Scan CTCSS
15 Scan DCS
16 CDCSS SAVE MODE
VOICE
17
- Voice Prompt
OFF [0] 15[1] - 180[12] in 15 second steps
(TIMEOUT-15)/15=[n]
OFF [0] | see CTCSS Table in Appendix C
OFF [0] | see DCS Table in Appendix C
OFF [0] | see CTCSS Table in Appendix C
OFF [0] | see DCS Table in Appendix C
OFF
OFF
ALL[0]｜RX[1]|TX[2]
OFF [0] | ON [1]
*This feature provides a safety switch that limits
transmission time to a programmed value. This will
promote battery conservation by not allowing you to
make excessively long transmissions, and in the event
of a stuck PTT switch it can prevent interference to
other users as well as battery depletion
Mutes the speaker of the transceiver in the absence of
a specific and continuous sub-audible signal. If the
station you are listening to does not transmit this
specific and continuous signal, you will not hear
anything.
Mutes the speaker of the transceiver in the absence of
a specific low-level digital signal. If the station you are
listening to does not transmit this specific signal, you
will not hear anything.
Transmits a specific and continuous sub audible signal
to unlock the squelch of a distant receiver (usually a
repeater).
Transmits a specific low-level digital signal to unlock
the squelch of a distant receiver (usually a repeater).
Allows scanning of CTCSS in VFO frequency mode.
This operation is not allowed in channel mode.
Allows scanning of DCS in VFO frequency mode. This
operation is not allowed in channel mode.
Save the scanned CTCSS/DCS in VFO mode.
•ALL: Save to R-CDCSS and T-CDCSS
•TX: Save to T-CDCSS only
•RX: Save to R-CDCSS only
Allows audible voice confirmation of a key press