Publicidad
Idiomas disponibles
Idiomas disponibles
BELTS AND BACKPACK
The 3M™ Versaflo™ Powered Air Purifying Respirator TR-600 is approved for use with either a belt or
backpack.
Belts
The TR-600 is approved for use with two premium belt options:
• The 3M™ Heavy Duty Belt TR-626 features a durable surface and leather straps.
• The 3M™ Easy Clean Belt TR-627 features a smooth deconable surface and urethane straps.
Select the belt appropriate for the work conditions.
To install the belt:
1. With a filter/cartridge and filter cover installed, place the motor/blower face down on a table with
outlet facing away from you.
2. Place the 4 keyholes (Fig. 9-2) of the belt onto the 4 T-bars (Fig. 9-1) on the back of the motor/blower
(Fig. 9-3).
3. Push down on the belt between the top and bottom keyholes on each side using your thumbs (Fig. 9-4).
4. Slide the belt up (Fig. 9-5) until the belt snaps over the belt locking tabs on the bottom of the motor/
blower (Fig. 9-6).
5. Gently tug on belt to ensure it is securely attached to the motor/blower unit.
6. Position the motor/blower. Typical use is to rest it in the small of the back. Tighten belt for a snug
comfortable fit. A belt extender is available if additional length is needed.
7. Secure excess belt length into the belt keeper. Excess belt length may be carefully trimmed if it will not
be needed.
To remove the belt from the motor/blower, lift the lower, center portion of the belt over the locking
edges and slide the belt down.
Fig. 8 Installing battery
9
Publicidad
