Publicidad
Idiomas disponibles
Idiomas disponibles
conducted the main filters must be replaced by new
ones.
•
When carrying out service or repair operations, all
contaminated items which cannot be satisfactorily
cleaned are to be disposed of; such items shall be
disposed of in impervious bags in accordance with
any current regulation for the disposal of such waste.
•
All the machine parts shall be regarded as
contaminated when removed from the working
area and appropriate action taken to prevent dust
dispersal.
•
The outside of the machine should be
decontaminated by vacuum cleaning methods and
wiped clean or treated with sealant before being
taken out of a working area.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the engine manual that is supplied by the
engine manufacturer.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
4. Make sure that only approved persons are in the
work area.
5. Do daily maintenance. Refer to
schedule on page 17 .
6. Make sure that the product is assembled correctly
and is not damaged.
7. Make sure that all bolts, screws and nuts are
tightened.
8. Make sure that the blast wheel, liners and sealing
are not damaged or worn out. Replace the parts
when 75% of the blade thickness has been worn
away.
9. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
storage and disposal on page 27 .
10. Make sure that the height of the rubber seals are 1
mm/0.04 in. above the surface.
11. Do a check of the oil level. Refer to
the engine oil level on page 23 .
12. Do a check of the fuel level.
13. Do a check of the hydraulic oil level.
2291 - 001 - 17.05.2024
Operation
Before you operate the
Maintenance
Transportation,
To do a check of
•
For user servicing, the machine shall be dismantled,
cleaned and serviced, as far as is reasonably
practicable, without causing risk to the maintenance
staff and others. Suitable precautions include
decontamination before dismantling, provision for
local filtered exhaust ventilation where the machine
is dismantled, cleaning of the maintenance area and
suitable personal protection.
•
It is necessary to provide for an adequate AIR
CHANGE RATE ACR in the room if the exhaust
air is returned to the room. Refer to National
regulations.
14. Make sure that the separator is filled with abrasive
Separator on page 12 or To fill
material. Refer to
the product with abrasive material on page 13 .
15. Make sure that the BigBag is empty. Refer to
discard a full BigBag and install a new BigBag bag
on page 15 .
Valve for the abrasive material
CAUTION:
abrasive material when the product is in
operation.
The valve for the abrasive material controls the flow of
the abrasive material to the blast wheel.
To operate the valve for the abrasive
material
CAUTION:
abrasive material when the product is in
operation.
1. Push the button on the control panel to open the
valve for the abrasive material. Refer to
panel overview on page 3 .
2. Push the button on the control panel to close the
valve for the abrasive material. Refer to
panel overview on page 3 .
To
Only open the valve for the
Only open the valve for the
Control
Control
11
Publicidad
