Publicidad
Idiomas disponibles
Idiomas disponibles
•
Turn the handle down to close the dust valve.
To select the correct speed
The product must have the correct speed for optimal
result. Examine the result and adjust the speed if
it is necessary, the speed (ft/min) is shown on the
speed level indicator. Use the different speed modes as
follows:
•
High speed on concrete surfaces for light treatment.
•
Standard speed on concrete surfaces for heavy
treatment.
•
Low speed for steel surfaces.
1. Sit on the seat.
2. Pull the bottom part of the movement control up.
3. Move the movement control lever to adjust the
speed.
a) To increase the speed for forward operation,
push the movement control lever.
b) To decrease the speed for forward operation, pull
the movement control lever in direction of the
neutral position.
c) To increase the speed for rearward operation,
pull the movement control lever.
d) To decrease the speed for rearward operation,
push the movement control lever in direction of
the neutral position.
To start the product
1. Turn the pinch bar 1 step. Refer to
bar on page 16 .
2. Turn the battery switch below the seat to ON.
14
3. Sit on the seat.
4. Make sure that the emergency stop button is
5. Make sure that the movement control lever is in the
6. Turn the ignition key to ON. The text "ENGINE
7. Wait until the text "ENGINE PREHEATING" does not
8. Turn the ignition key to START position.
9. Set 2200 rpm with the button to increase the engine
10. Do a check of the fuel level on the control panel.
To operate the product
1. Make sure that the work area is safe. Refer to
2. Fill the separator with abrasive material. Refer to
3. Open the dust valve. Refer to
4. Start the product. Refer to
5. Push the "Freeflow" button to lower the shot blaster
6. Push the button to engage the clutch (B) to start the
7. Push the movement control lever (C) forward from
To turn the pinch
8. Use the steering wheel (D) to control the front wheel
disengaged.
neutral position.
PREHEATING" shows on the display.
show on the display.
RPM. The engine RPM value shows on the display.
Display overview on page 4 .
Refer to
WARNING:
shot blaster head during operation. Abrasive
material comes out of the product at high
speed and can cause injury.
area safety on page 8 .
fill the product with abrasive material on page 13 .
valve on page 13 .
page 14 .
head (A). The shot blaster head is on the ground
after approximately 5 seconds.
A
D
blast wheel and the dust collector.
neutral position to move the product forward.
CAUTION:
operate rearward.
and the direction of the product.
Do not lift the cover of the
Work
To operate the dust
To start the product on
B
C
The product does not
2291 - 001 - 17.05.2024
To
Publicidad
