Husqvarna BMR 75D Manual Del Usuario página 19

1. Remove the 3 nuts (A).
B
A
2. Remove the support strip (B).
3. Remove the outer rubber seal (C).
4. Remove the brush list seal (D).
5. Remove the inner rubber seal (E).
6. Install the new seals in the opposite sequence.
To replace the brush list seal
1. Remove the 3 nuts (A) and the support strip (B).
B
A
2. Remove the brush list seal (C).
3. Install the new brush list seal 6 mm/0.25 in. above
the surface.
4. Install the support strip and the 3 nuts.
2291 - 001 - 17.05.2024
E
D
C
C
To replace the pinch bar
1. Remove the bolt and the clamp (A).
2. Remove the nut and the retainer (B).
3. Turn the pinch bar with a wrench.
4. Remove the starwheel (C).
A
B
C
19