Husqvarna BMR 75D Manual Del Usuario página 16

To drain the water from the pressure
tank
Water in the pressurized air collects in the pressure
tank. It is necessary to drain the water from the pressure
tank daily.
1. Stop the product. Refer to
page 15 .
2. Put a container below the water valve (A) to collect
the water.
A
3. Open the water valve slowly.
4. Close the water valve when all the water is drained.
To adjust the suction power
Use the air flow hatch on top of the product to adjust
the suction power. It is necessary to adjust the suction
power for example when the primary filters are new or
the suction is not satisfactory.
• Adjust the suction power with the air flow hatch.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
16
To stop the product on
Maintenance
Before you do
a) For less suction power, open the hatch.
b) For more suction power, close the hatch.
To turn the pinch bar
1. Remove the bolt and the clamp (A).
2. Remove the nut and the retainer (B).
3. Turn the pinch bar with a wrench.
4. Install the nut and the retainer.
5. Install the bolt and the clamp.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
A
B
Use personal protective
Personal protective
2291 - 001 - 17.05.2024