Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
maintenance, stop the engine. Remove the
ignition key to prevent an accidental start.
Let the product become cool.
For all servicing and repair work on the product,
special training is necessary. Husqvarna guarantees
professional repair and servicing near you. If your dealer
is not a service agent, speak to them for information
about the nearest service agent.
General product mainte-
nance
Empty the dust collector.
Do a check of the of the
separator and the separa-
tor tray.
Lubricate the blast wheel
bearings. Make sure that
the bearings rotate during
To lu-
lubrication. Refer to
bricate the product on page
18 .
Do a check of the elec-
trical components, the ca-
bles and the connections
for wear and damages.
Examine the engine for dirt
and damage.
Make sure that the dust
collector hose is not dam-
aged and that there is no
blockage.
Make sure that nuts and
screws are tight.
Clean the product.
Do a check of all safety de-
vices.
Do a check of the brush
list seals and rubber seals
around the shot blaster
head for wear.
Do a check of the blast
wheel, blast wheel blades,
pinch bar and liners for
To do before
wear. Refer to
you operate the product on
page 11 .
Do a check of the tension
of the drive belt for the shot
blaster head.
2291 - 001 - 17.05.2024
Before you do the
Each 3 h
Daily
X
X
X
*
*
*
*
X
X
X
X
X
For more information, refer to www.husqvarnacp.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Each 60 h
Each 600 h
Monthly
Yearly
17
Publicidad
