Publicidad
Idiomas disponibles
Idiomas disponibles
General product mainte-
nance
Lubricate and adjust the
grease nipple on the
1
clutch.
Replace the engine oil.
Lubricate the bearings of
the frontwheel.
Replace the hydraulic oil
2
and hydraulic oil filter.
Do a complete servicing
and cleaning of the prod-
uct.
Do a check and replace a
bearing.
To clean the product
•
Always clean all the equipment after use. Use a
vacuum cleaner.
•
Do not use a high-pressure washer to clean the
product.
•
Keep the air openings clean and clear to make sure
that the product always has sufficient air flow.
To clean the dust collector
1. Close the dust valve. Refer to
valve on page 13 .
2. Clean the external surface with a moist cloth.
CAUTION:
electrical components.
3. Clean the HEPA filter with a dust extractor.
WARNING:
extractors with HEPA filter and a soft
brush to not do damage to the HEPA
filter. Do not clean the dust extractor with
compressed air or water.
WARNING:
make a hole in the HEPA filter. This can
cause damage to the HEPA filter and a
health risk for the operator or others.
1
Lubricate the grease nipple on the clutch after the first 20 running hours. After that, lubricate the grease nipple
on the clutch each 60 hours.
2
Replace the hydraulic oil and hydraulic oil filter minimum 1 time during the year or each 150 hours.
18
Each 3 h
Daily
To operate the dust
Do not use water on
Always use dust
Do not put tools on or
Each 60 h
Each 600 h
*
O
To lubricate the product
•
Lubricate the 4 grease nipples with 0.2-0.3 oz / 5-10
g of grease for each grease nipple.
To replace the front and sides seals
Monthly
Yearly
*
X
O
O
2291 - 001 - 17.05.2024
Publicidad
