Publicidad
Idiomas disponibles
Idiomas disponibles
Abrasive material seal
The abrasive material seal is a seal system with the
front seal (A), the side seals (B) and the rear brush list
seal (C).
To set the correct height of the abrasive
material seal
1. Park the product on a flat surface.
2. Push the "Freeflow" button to lower the shot blaster
Control panel overview on page 3 .
head. Refer to
3. Stop the product and make sure that there is no risk
of accidental start. Refer to
page 15 .
4. Loosen the 3 nuts and and the support strip on the
side seals and the front seal.
5. Adjust the height on the side seals and the front
seal.
a) Adjust the height until the inner rubber seal is 1
mm/0.04 in. above the surface.
b) Adjust the height until the brush list seal is 6 mm/
0.25 in. above the surface.
c) Adjust the height until the outer rubber seal is 1
mm/0.04 in. above the surface.
6. Tighten the 3 nuts.
12
A
B
B
C
To stop the product on
7. Loosen the 3 nuts and the support strip on the rear
brush list seal.
a) Adjust the height until the rear brush list seal is 6
mm/0.25 in. above the surface.
8. Tighten the 3 nuts.
Abrasive material
Speak to your Husqvarna dealer for the selection of
correct abrasive material for your surface operation.
Approved abrasive material on page 29 .
Refer to
Separator
The separator keeps the abrasive material
contamination free. The separator holds the abrasive
material and supplies the blast wheel with abrasive
material.
2291 - 001 - 17.05.2024
Publicidad
