9. Push the button to open the valve for the abrasive
material.
CAUTION:
before you open the valve for the
abrasive material.
10. After 5 m/16 ft., close the valve for the abrasive
material.
11. Stop the product. Refer to
page 15 .
12. Do a check of the blast pattern. Set the correct
To select the correct speed on page
speed. Refer to
14 .
Blast pattern
The blast pattern (A) is the surface that has received
treatment.
A
These are the conditions that have effect on the blast
pattern:
•
Operation speed.
•
Increased wear on the blast wheel and pinch bar.
•
The dimension of the abrasive material.
•
Different types and hardness of the surface.
To stop the product
1. Push the button to close the valve for the abrasive
Control panel overview on page 3 .
material. Refer
CAUTION:
for the abrasive material is fully closed
before you stop the product.
2. Operate the product continuously for 10 seconds to
make sure that there is no material in the system.
3. Set the movement control lever to the neutral
position.
4. Push the button to disengage the clutch.
5. Set 1300 RPMs with the engine RPM control.
2291 - 001 - 17.05.2024
The product must move
To stop the product on
Make sure that the valve
6. Push the button to lift the shot blaster head.
7. Turn the ignition key to OFF.
8. Remove the ignition key from the product.
To discard a full BigBag and install a
new BigBag bag
WARNING:
caution, a full BigBag can be heavy. Make
sure that the cable ties are closed correctly
before you lift the BigBag.
WARNING:
protection when you empty the dust
collector. Refer to
equipment on page 7 .
1. Close the dust valve. Refer to
valve on page 13 .
2. Remove the funnel of the BigBag from the dust
outlet and close it.
3. Pull the BigBag off the support rods.
4. Obey local regulations for disposal of the full BigBag
bag.
5. Install the funnel of the BigBag (A) on the dust outlet
(B).
B
C
A
6. Attach the funnel of the BigBag on the dust outlet
with straps (C).
7. Make sure that the BigBag hangs equally on the
support rods.
8. Open the dust valve. Refer to
valve on page 13 .
Lift the BigBag with
Use approved respiratory
Personal protective
To operate the dust
To operate the dust
15