Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The product does not
operate correctly.
The abrasive material
falls out of the prod-
uct.
The wear is more
than usual on parts of
the shot blaster head.
The product does not
move.
The engine does not
start.
26
Cause
The supply of abrasive material to the blast
wheel is not sufficient.
The type of abrasive material is incorrect for
the surface.
The abrasive material has contamination.
The blast wheel is worn or damaged.
The blast wheel blades are worn or dam-
aged.
There is too much abrasive material that hits
the surface at the start of the operation.
The speed of the product is too high.
The pinch bar is worn.
The position of the pinch bar is incorrect or
the pinch bar is worn.
The dust valve is closed.
The filters are clogged.
The seals are at an incorrect distance from
the surface.
The seals are damaged.
The shot blaster head is at an incorrect dis-
tance from the surface.
The type of abrasive material is incorrect for
the surface.
The suction power of the dust collector is
insufficent.
The speed is too low.
The shot blaster head gets caught on the
floor.
The drive system is damaged.
The emergency stop button is engaged.
The engine is damaged.
The battery switch is in the OFF position.
The battery is empty.
The fuel tank is empty.
Solution
Clean the separator tray and refill the sepa-
rator with abrasive material.
Do a check of the valve for the abrasive ma-
terial.
Replace the abrasive material with correct
abrasive material for the surface.
Do a check of the primary filters and replace
if it is necessary.
Replace the blast wheel.
Replace the blast wheel blades.
Close the valve for the abrasive material and
stop the product.
Decrease the speed.
Replace the pinch bar.
Turn the pinch bar 1 step or replace the
pinch bar.
Open the dust valve.
Replace the primary filters and do a check
for leakages.
Adjust the height of the seals.
Do a check of all the seals and replace if it is
necessary.
Adjust the height of the shot blaster head.
Replace the abrasive material with correct
abrasive material for the surface.
Replace the primary filters.
Increase the speed.
Adjust the height of the shot blaster head.
Speak to your dealer for more information.
Turn the emergency stop button clockwise to
disengage.
Speak to an approved Husqvarna service
agent.
Turn the battery switch to the ON position.
Charge the battery with a workshop charger.
Fill the tank with fuel.
2291 - 001 - 17.05.2024
Publicidad
