Indication of the charging process:
Charger
Battery is charging.
The on time of the LED indicates the current battery charge level.
The on time of the LED gets longer as the charge level increases. It only flashes
briefly at the start of the charging process and stays on continuously at the end of
the charging process.
Battery is fully charged, or the temperature fell above/below the permissible range
during charging. Check current charge level (see Page 43).
6.3 Display of the current charge level
Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
7 Use
7.1 Movement pattern in activity mode A
(if the knee joint is permanently locked)
7.1.1 Standing
The knee joint is locked in the flexion direction. Therefore, proceed as you
would with a rigid knee joint.
INFORMATION: In response to a sitting movement, the joint switches to
high flexion resistance.
1) Turn the prosthesis 180° (the sole of the foot has to face up).
2) Hold still for 2 seconds and wait for beeps.
Vibration signal
3x long
5x long
Battery charge level
more than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
less than 20%
43