Mounting - SICE S 45 Basic Manual De Instrucciones

7) Depress pedal (7, Fig. L) to bring the arm (11, Fig. L) will tilt to its non-working position. Remove the tyre.
CHECKING TYRE AND RIM
WARNING: This checking of tyre and rim is of the utmost importance to prevent the tyre from bursting during bead seating and in-
flating operations!
Before beginning mounting operations make sure that:
- the tyre is not damage and the cord fabric is not damaged.
If you note defects do not mount the tyre.
- the rim is without dents and is not warped.
NB: particularly with alloy rims, dents can cause internal micro-cracks not
visible to the naked eye.
This can compromise the rim and can also be a source of danger especially
during inflation.
- the diameter of the rim and tyre are EXACTLY the same.
NB: the diameter of the rim is stamped on the rim. The diameter of the
tyre is stamped on the tyre wall. NEVER try to mount a tyre on a rim if you
cannot identify the diameters of both.

MOUNTING

1) Apply a liberal amount of manufacturer recommended rubber lubricant to
tyre beads and rim well.
2) If the rim has been removed from the table top, clamp it back on the table
as previously described in the section on "CLAMPING THE WHEEL".
3) Depress the pedal (7, Fig. L) to bring the arm (11, Fig. L) to its working
position.
When moving the tool arm to its work position, do not
place your hands on the rim.
There is always the risk of hands being crushed
between the tool head and the rim.
4) Position the mount/demount tool (16, Fig. L) by hand against the edge
of the rim. Lock the vertical slide (10, Fig. L) and swing arm (11, Fig. L) as
described under 2 of the demounting procedure.
IMPORTANT! If you are mounting a tyre previously demounted or on wheels
with the same size rims, there is no need to use the handle (9, Fig. L) every
time to lock or unlock the swing and vertical arms. Simply tilt back the
tower (8, Fig. L) and reposition it with the pedal (7, Fig. L).
To prevent industrial accidents, keep hands and other
parts of the body as far from the tool arm as possible
when the table top is turning.
5) Guide the tyre so that the lower bead is above the forward portion of the
mount/demount head (16, Fig. L : See Fig. P).
S 45 Basic
10.4 MOUNTING
2
7
36
ENGLISH • Instructions manual
11
9
10
16
12
6
5
1
15
3
8
4
14
13
L
P