Tocs (Tohatsu Onboard Communication System) Installation - TOHATSU MFS 40A Manual Del Propietário

26
INSTALLATION
Propeller must be selected that will
allow the engine to reach recommended
maximum operating range during cruis-
ing.
Wide-open throttle rpm range
5000 – 6000 rpm
Genuine propellers are listed on PRO-
PELL ER TABLE of this manual ( S e e
page 85).
1. Remove the split pin, propeller nut
5
and washer.
2. Apply water proof grease to the pro-
peller shaft before installing a new
propeller.
3. Install the thrust holder, propeller
stopper, washer and propeller nut
onto the shaft.
1. Propeller
2. Thrust holder
3. Stopper
4. Washer
5. Nut
6. Split pin
4. Tighten the propeller nut to speci-
fied torque with holding the propel-
ler by wood block. And align one of
grooves to propeller shaft hole.
Propeller nut torque:
35 N·m (25 ft·lb, 3.5kgf·m)
40/50
-1
(rpm)
1
3
4
2
5
ENOF00084-A
5. Install a new split pin into the nut
hole and bend it.
ENOM00971-0
5. TOCS (Tohatsu Onboard
Communication System)
installation
TOCS (Tohatsu Onboard Communication
System) interface coupler can provide
information regarding engine speed,
fuel consumption, and various malfunc-
tion via an optional interface cable.
Contact authorized Tohatsu dealer for
more detail.
6
ENOF00084-B
ENOF00933-0