Engine Oil Replacement - TOHATSU MFS 40A Manual Del Propietário

Ocultar thumbs Ver también para MFS 40A:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

68
INSPECTION AND MAINTENANCE
Description
Bolts and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
ENOM00091-A

Engine oil replacement

ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after stop-
ping. Changing engine oil should be done
after the engine has been cooled.
ENOW00092-A
Do not overfill engine oil, or engine oil
10
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
Be sure that outboard motor is in upright
and level position when che cking or
changing oil.
Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is
found, or engine could be severely dam-
aged. Consult dealer.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
Inspection intervals
First 20
Every 50
Every 100
hours of 1
hours of 3
hours of 6
month
months
CAUTION
CAUTION
Every 200
Inspection procedure
hours of 1
months
year
Retighten
Apply and pump in grease. (See
page 78)
Check for corrosion.
Check for corrosion and deformation.
ENOW00090-0
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
ENOW00933-0
Engine oil mixed with dust or water will dra-
matically shorten the life of the engine.
To change engine oil:
Be sure to use recommended engine oil
(see page 13).
1. Stop the engine and allow it to cool.
2. Tilt up the outboard motor and lock
the tilt with the tilt stopper.
3. Turn the steering on the outboard
motor so that the drain hole is facing
downward.
4. Put a oil drain pan under the oil drain
screw.
5. Remove the oil drain screw and
completely drain oil from the engine.
Remarks
Replace if
necessary.
CAUTION
CAUTION

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Mfs 50a003-11106-7ah1

Tabla de contenido