351 (13.82)
327 (12.87)
163.5
Ø12.5
125.5
251 (9.88)
ENOW00008-A
CAUTION
Mounting bolts should be installed with
the bolt head at inside sur face of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-0
Notes
1.
Apply sealing agent, such as silicone
sealed between the bolts and the
transom board holes before tighten-
ing the bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
163.5
Ø12.5
125.5
ENOF00018-A
ENOM00840-0
2. Remote control device
installation
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a posi-
tion where it is easy to reach and oper-
ate the controls.
Make sure there are no obstacles that
can interfere with the operation of the
remote control cable.
ENOW00850-0
Remote control cable length
ENOW00100-A
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 in) or
less. Otherwise, it affects the service life of
the cable.
23
INSTALLATION
3
1, 2
5
ENOF00841-1