Cooling Water Check Port; Trim Tab - TOHATSU EverRun MX50D2 Manual De Servicio

Service Information
1 1
1
2

2 Trim Tab

Do not reuse.
å
1 1
2
3
1 Trim Tab
2 Anti-Ventilation Plate
3 Steering Pivot (Swivel Shaft)
1-22
All manuals and user guides at all-guides.com

7) Cooling Water Check Port

8) Trim Tab
3
∫
2
3
Check that cooling water check port 1 discharges water
during engine operation.
Adjustment of trim tab angle
After installing outboard motor on the boat, use trim tab to
achieve balance between port and starboard steering
loads. Loosen trim tab nut or bolt 2, adjust angle of trim
tab 1 as described below, and then tighten the nut to
specified torque.
Trim Tab Nut or bolt 2 :
13 N · m (9 lb · ft) [1.3 kgf · m]
Example of Adjustmentt
å If it is necessary to steer to starboard to make boat run
straight or if boat steers itself to port when steering is
held amidships, move trailing edge of trim tab to port
side, or
∫ If it is necessary to steer to port to make boat run
straight or if boat steers itself to starboard when
steering is held amidships, move trailing edge of trim
tab to starboard side.
Change trim tab angle a little for each test run and
repeat the process several times until the best
position is found.
GB
2st 50D2 2011