Important - JVC TH-M65 Manual De Instrucciones

Getting started
Remote control
mode selector
For TV operations
You can operate your TV using the remote control supplied with
this system.
• Refer also to the instruction manuals supplied with your TV.
% To set the manufacturer's code
You can operate a JVC TV without setting the remote control
signal.
1
Slide the remote control mode selector
to TV.
2
Press and hold . TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
17
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV:Press 0, then 8.
Manufacturer
JVC
Hitachi
Magnavox
Karaoke mode
switch Mitsubishi
Panasonic
(play button)
RCA
5
Release . TV.
6
Try operating your TV by pressing
. TV.
When your TV turns on or off, you have entered the correct
code.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
Number
buttons
NOTE
• Manufacturers' codes are subject to change without notice. If they are
changed, this remote control cannot operate the equipment.
• Set the codes again after replacing the batteries of the remote control.
% Operation

IMPORTANT

Before using the remote control to operate a
TV;
• Set the remote control mode selector to TV.
The following buttons are available:
F TV:
TV VOL +/–:
TV/VIDEO:
CHANNEL +/–*:
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
* Be sure to set the Karaoke mode switch to OFF before using
CHANNEL +/–. (for TH-M65 only)
For DBS tuner or CATV converter
operations
You can operate your DBS tuner or CATV converter using the
remote control supplied with this system.
• Refer also to the instruction manuals supplied with your DBS
tuner or CATV converter.
% To set the manufacturer's code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press and hold DBS.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
Code Manufacturer
01 Samsung
10 Sanyo
02 Sharp
03 Sony
04, 11 Toshiba
05 Zenith
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Code
12
13
06
07
08
09