Connecting The Power Cord - JVC TH-M65 Manual De Instrucciones

Getting started
Setting the VOLTAGE SELECTOR switch
To avoid damaging the powered subwoofer, set the VOLTAGE SELECTOR switch on the rear panel to the correct voltage for your area.
When you change the position of the VOLTAGE SELECTOR switch, use a tool such as a slotted screwdriver, etc.
CAUTION
DO NOT plug the power cord of the powered subwoofer before setting the VOLTAGE SELECTOR switch to the correct
voltage.

Connecting the power cord

Make sure that all connections have been completed, before plugging in the power cords of the center unit and powered subwoofer.
1
Firmly insert the supplied power cord into the Ó AC IN socket on the rear of the center
unit.
2
Plug both power cords into AC outlets.
Center unit
Plug into AC outlets.
CAUTION
• Disconnect the power cord before cleaning or moving the system.
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp and pull the plug so as not to damage the cord.
NOTE
• Keep power cords away from other connected cords. The power cords may cause noise or screen interference.
• Preset settings, such as preset stations and surround mode adjustment, may be erased in a few days in the following cases;
If you unplug the power cord of the center unit.
•
If a power failure occurs.
•
• The speakers will not produce any sound if the power cord of the powered subwoofer is removed from the AC outlet while the center unit is turned on.
In this case, press F AUDIO on the remote control or F STANDBY/ON on the center unit to turn the power off, plug in the powered subwoofer,
then press F AUDIO or F STANDBY/ON again.
• If the AC outlets do not match the AC plugs, use the supplied AC plug adaptors.
15
Powered subwoofer
Power cord
(supplied)
Power cord
Powered subwoofer