Adjusting The Bracelet (St And Tt Models) - Suunto OBSERVER TT Guía De Usuario

of in fire or water. Replace only with manufacturer
specified batteries. Recycle or dispose of used
batteries properly.
1.5 ADJUSTING THE BRACELET (ST
AND TT MODELS)
The metal / elastomer bracelets of the Observer
models St and Tt have to be adjusted for the
user. The steps are
1. Remove the buckle by releasing the spring
bars with pin, paper clip or other sharp object.
2. Remove both spring bars from the pin holes.
3. Shorten the bracelet by cutting along the
grooves on the inner surface of the bracelet.
You can do this for instance with scissors. If
you are unsure of the correct length, cut the
pieces one by one and test the length after
cutting each piece. Cut in turns from both sides
of the bracelet to keep the sides equally long.
Be careful in order not to shorten the bracelet
too much.
4. Replace the spring bars into the last pin holes
of both sides of the bracelet.
5. Attach the buckle to the bracelet by placing
the spring bars into the holes in the buckle. In
both sides of the buckle are holes for two dif-
ferent positions. This can be used for fine ad-
8