Husqvarna TC 250 2009 Manual De Uso página 112

MUM2-250_310_450_510_2009_GB
DISC CLEANING
Poor braking can also be caused by oil on the disc. Oil or
grease on the disc must be cleaned off with a high flash-point
oil free solvent, such as acetone or lacquer thinner.
46
18-11-2008 11:18 Pagina 46
FLUID CHANGE
The brake fluid should be checked and changed in accordance
with the Periodic Maintenance Chart or whenever it is contami-
nated with dirt or water. Don't change the fluid in the rain or
when a strong wind is blowing.
CAUTION!
* Use only brake fluid from a sealed con-
tainer (DOT 4). Never use old brake fluid.
* Never allow contaminants (dirt, water,
etc.) to enter the brake fluid reservoir.
* Don't leave the reservoir cap off any
length of time to avoid moisture contami-
nation of the fluid.
* Handle brake fluid with care because it
can damage paint.
* Don't mix two types of fluid for use in the
brake. This lowers the brake fluid boiling
point and could cause the brake to be in-
effective. It may also cause the rubber
brake part to deteriorate.