Throttle Cable Adjustment - Husqvarna TC 250 2009 Manual De Uso

MUM1-250_310_450_510_2009_GB

THROTTLE CABLE ADJUSTMENT

To check the correct adjustment of the throttle operate as fol-
lows:
- remove the upper rubber cap (1);
-
by moving cable (2) back and forth check for 2 mm. clearance;
- should the clearance be incorrect, unblock the counter ring-
nut (3) and turn the adjusting screw (4) (by unscrewing it,
the clearance is reduced, while by screwing screw (4) it is
increased);
- tighten the counter ring-nut again (3).
WARNING*: Operation with damaged throt-
tle cable could result in an unsafe riding
condition.
WARNING*: Exhaust gas contains poisonous
carbon monoxide gas. Never run the engine
in a closed area or in a confined area.
22
18-11-2008 11:09 Pagina 22
NOTE
In case of throttle control cables (1) and (2) replacement it is
necessary to respect, during reassembly, the measure Á
(10mm/0.4 in.), as shown in the picture. Then reassemble
guard cover (B) using screw (3) and adjust throttle control ca-
bles on handlebar as described at side.
To replace throttle control cables, first remove tha fuel tank.
3
B
2
1