Checking The Oil Level - Husqvarna TC 250 2009 Manual De Uso

MUM1-250_310_450_510_2009_GB

CHECKING THE OIL LEVEL

Keeping the motorbike level and in a vertical position, check the
oil level through the inspection (1) window on the right
crankcase. Check if level (a) is about midway of the inspection
porthole.
To fill up, remove the filler cap (2).
Note*: Have this operation made with
warmed-up engine.
WARNING*: Be careful not to touch hot en-
gine oil.
1
2
18-11-2008 11:09 Pagina 19
ENGINE OIL REPLACEMENT AND BAG FILTERS- NET FIL-
TER FILTER CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot en-
gine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- remove oil filler cap (2);
- remove the engine guard (A)
- place an oil drain pan under the engine block
- Remove the oil drain cap (3), the mesh filter (4) and drain
the old oil;
- Clean the mesh filter with benzine;
a
A
3
- in order to replace the filter cartridge (5), unscrew the three
fastening screws then the filter cartridge cover (6).
Once the oil filters have been cleaned-replaced, fit the parts
back in, in the opposite sequence to the disassembly, and pour
in the prescribed amount of oil, as listed in the LUBRICATION
TABLE on page 9.
4
6
5
19