Replacing The Muffler Deadening Material - Husqvarna TC 250 2009 Manual De Uso

MUM2-250_310_450_510_2009_GB

REPLACING THE MUFFLER DEADENING MATERIAL

Remove the saddle after turning the locking back pin (1) anti-
clockwise, loosen the screws (2) remove the side panel (3).
2
18-11-2008 11:19 Pagina 53
Using an 8 mm T-shaped spanner on the outside and a 10 mm
T-shaped spanner on the inside, remove the locking screw (4)
of the muffler. Remove the spring (5) and pull out the muffler
(A) o (B). Remove the four rear rivets (6), clamp and the ex-
haust terminal (7).
3
Remove innner pipe and replace the deadening material.
Reassemble L.H. side panel and saddle.
NOTE*: When diffuculties are found in re-
moving the muffler, lightly beat with a rub-
ber or plastic hammer.
6
7
4
8
5
53