Routine Maintenance - EMAK CR 270 Serie Manual De Uso Y Manitenimiento

during operation and remain hot for a
while after the engine is stopped. To
I
reduce risk of burns do not touch the
silencer and other parts while they are hot.
- Frequently check for the accumulation of
GB dry grass or similar materials, around the
engine and especially around the exhaust
pipe; carry out periodic cleaning and
remove even the smallest quantities of such
F
materials.
- Never modify the machine in any way.
D
- Replace safety devices as soon as they
become damaged or broken. Replace worn
blades.
E
- Keep all nuts, bolts and screws tightened to
guarantee safe operating conditions.
NL

7.2 Routine Maintenance

The following list is to help you maintain your
machine's safety and performance. It shows the
P
main maintenance and lubrication operations
and their frequency.
H
Machine
1. Check and adjustment of the
throttle lever (2)
SK
2. Check and adjustment of the
clutch lever (2)
CZ
3. Check and adjustment of
parking brakes (2)
RUS 4. Check and adjustment of
UK
crawlers unlock levers (2)
5. Crawlers rollers lubrication
with grease
PL
6. Check transmission belt (2)
7. Replace transmission belt (1)
FIN
(2)
8. Check all fastening elements
BIH
SRB
9. General lubrication (3)
HR
10. Transmission oil replacement
(1st time) (2)
11. Transmission oil replacement
(following times) (2)
32
1) At the first signs of malfunction, contact
your Dealer immediately.
2) This operation must be carried out by
your Dealer or an Authorised Service
Centre.
3) General lubrication should also be
carried out whenever the machine is to
be left unused for a long period.
Engine
See the engine manual for the full list and
frequency.
Change engine oil (also see paragraph below) -
Check and clean air filter - Replace air filter -
Check fuel filter - Replace fuel filter - Check and
clean spark plug points - Replace spark plug
CAUTION: Follow the instructions in the
engine manual.
Changing the engine oil
CAUTION: The oil discharge operation is
easier to perform if the oil is warm.
Emak Engine:
25 hours
1. Place a suitable container below the engine
to catch the used oil and then remove the oil
25 hours cap (A, Fig. 18), the drain bolt (B) and sealing
washer (C).
2. Allow the used oil to drain completely, and
25 hours
then reinstall the drain bolt and sealing
washer, and tighten it securely.
25 hours
Honda Engine: In this engine, to empty the
tank, it is necessary to suck the oil from the filler
20-30 hours
pipe, using a syringe.
25 hours
3. With the engine in a level position, fill to the
upper limit (MAX) mark on the dipstick with
-- hours
the recommended oil (Fig. 19).
25 hours
4. Reinstall the oil cap securely (A).
25 hours
CAUTION: Running the engine with a low
oil level can cause engine damage.
50 hours
WARNING: Please dispose of used
e n g i n e o i l i n a m a n n e r t h a t i s
500 hours
compatible with the environment. Used