Babyauto More Werdu RWF DS15 Manual De Instalación página 42

3. Make sure that the displayed arms corresponds to the
selected installation, group 0 (rearward facing) or group
1/2/3 (forward facing) (fig. 9).
* The insertion guides facilitate the installation of the
safety seat with the aid of the ISOFIX securing points
and prevents damage to the upholstery. When not in use
they should be removed and stored in a safe place. In
vehicles with a reclining back the insertion guides should
be removed before the seat is reclined. Problems that
may arise are generally the result of accumulation of dirt
or foreign bodies in the insertion guides and the clasps.
To solve this type of problem simply clean the part in
question.
5. Make sure the 5-point harness of the safety seat has
been correctly installed (see section 3).
6. Follow the steps described in section 3.7.
7. Recline the seat fully. Pull the lever
adjust the angle of recline to position 4 without releasing
the lever. Release the lever when the seat is in the desired
position (fig. 10).
8. Make sure the Isoclick Fix arms are displayed to install the
car seat backward facing (group 0+/1).
9. Place the seat in the back seat of the vehicle in opposite
direction of travel.
10. Hold the safety seat with both hands and insert the two
Isoclick Fix arms
until they fasten with a click on both sides. The red button
will partially change to green on both sides (fig. 11).
11. Shake the seat to check that it is correctly anchored to the
vehicle's ISOFIX points.
42
(12)
(19) firmly into the insertion guides
fig. 11
forward and
fig. 12
(26)
fig. 10
4
1 2 3
OK
CLICK