Babyauto More Werdu RWF DS15 Manual De Instalación página 44

5. PLACING THE CHILD IN THE SEAT.
GROUP 0+/1
TIP: The more snugly the harness fits over the child's
body, the better the child will be protected. therefore
avoid putting thick clothes on your child under the belt.
1. Release the harness buckle
2. Press the harness adjuster button
pulling the part of the harness straps that cross
the chest in order to loosen them fig. 2). Do not
pull the shoulder protectors.
3. Place the child in the safety seat.
4. Make sure the child's back rests firmly against the
back of the safety seat.
5. Bring the two clasps together
before inserting them into the harness buckle
You should hear a click (fig. 16).
6. Pull the harness adjustment strap
tighten and adjust it correctly to the child's body (fig.
17).
IMPORTANT! The part of the harness straps that
crosses the abdomen should be placed as low as
possible on the child's hip.
7. Pull down on the shoulder protectors
ensure they are properly in place.
For the safety of the child the following checks
44
(7)
(fig. 15).
(13)
while
(5) and join them
(7)
.
(14)
in order to
(3)
to
fig. 15 fig. 16
(14) Harness
adjust strap. fig. 17
should be made before every trip:
• The safety seat is firmly installed in the vehicle.
• The straps are not twisted.
• The safety seat straps are firmly fastened around
the child's body, without squashing it.
• The shoulder straps
CLICK
14
(10) are correctly adjusted