Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. If you wish to install the car seat using the Isoclick
Fix® system, follow the instructions described in
chapter 6.1
4. Place the safety seat on the vehicle seat in the
direction of travel.
5. Place the seat in the desired position (1, 2 or 3),
(fig.18).
6. Place the child in the seat. Pull the vehicle safety belt
and pass it in front of the child until it reaches the
vehicle seat belt buckle.
IMPORTANT! Make sure the belt is not twisted.
7. Insert the clasp into the vehicle seat buckle. You
should hear a click.
8. Place the diagonal part of the belt
that crosses the lap
safety seat buckle, through the abdominal belt guide
(11)
of the safety seat (fig. 22 B).
9. Pass the diagonal part of the belt
diagonal belt guide (group 2)
it is fully extended and not twisted (fig. 22 A).
10.
Make sure the diagonal part of the belt passes
over the child's collar bone and not the neck.
IMPORTANT! The part of the abdominal belt
rest as low as possible over the child's hips, on both sides.
TIP: If the seat back covers the guide
the headrest, which will allow you to insert the diagonal
section of the belt easily. You should then reset the
headrest to the correct height, as shown in point 3.8.
(27)
and the part
(28)
on the side of the vehicle
(27)
through the
(2)
on the headrest until
(28)
(2)
you can raise
(2)
Diagonal belt
guide (group 2/3).
(27)
Diagonal belt
section.
(28)
Abdominal belt
section.
(29)
Vehicle's belt
buckle.
(11)
Abdominal
belt guide
(group 0+/1/2/3).
should
TIP: You can readjust the height of the vehicle
headrest.
To ensure the child's safety, the following items
should be checked before every trip:
fig. 22
29
B
11
29
2
A
27
28
47
Publicidad
Tabla de contenido
