Removing The Cover - Babyauto More Werdu RWF DS15 Manual De Instalación

18
17
4. Lift the fabric cover and keep the harness straps
folded in the corresponding seat hollow so that they
do not disturb the child. Replace the cover in its
place.
5. Turn the seat over and, from the back, free the
(7)
belt buckle by passing the retention plate
(24)
through the slot in the seat (fig. 5).
6. Remove the belt buckle and save it in the
storage bag.
7. Take off the harness straps by pulling them out of
the seat.

3.5. Removing the cover

A) Headrest.
1. Adjust the headrest to its highest position.
fig. 4
2. First remove the part of the cover that includes the
B) To remove the 5-point harness, see point 3.4.
3.6. Putting the cover back on
Follow the same steps in reverse order.
IMPORTANT! Never use the safety seat following
the installation instructions described in point 5
without having a correctly installed buckle. Make
sure the metallic plate
(2)
safety belt guide followed by the remainder of
the headrest cover.
Remove the back and base covers.
(24)
24
is properly secured.
39