Capacity Label Instructions - Mettler Toledo IND560 PDX Guia De Instalacion

Capacity Label Instructions

The regulations in some locations require that the scale capacity and increment be
shown on the front of the terminal, near the display. To satisfy this requirement, a
blue capacity label is included with the terminal that must be completed and
adhered to the front overlay.
The capacity label (shown in Figure 2-62) provides space for the Max, min, and e
information for each range or interval for which the scale is programmed. If only
one or two ranges are used, the unused portion of the label may be cut off with
scissors. Written information must be legible and a minimum of 2mm or 0.08 in.
in height. A permanent marker should be used for this information.
Clean any oil or other contaminants from the area of the overlay shown in Figure
2-63 where the capacity label will be added. Peel the backing from the label and
adhere it to the overlay in the location shown in Figure 2-63, or another location
acceptable to the local regulations.
Capacity Label
in Place
Figure 2-61: W3 Jumper Location
Figure 2-62: Preparing the Capacity Label
Figure 2-63: Capacity Label Installed
IND560 PDX Installation Manual
Cut at dotted line to remove
unused ranges/intervals
2-37