Periodic Inspection - TOHATSU M 40D2 Manual Del Propietário

70
INSPECTION AND MAINTENANCE
ENOM01006-0

2. Periodic Inspection

It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or number
of months, whichever comes first.
Item
Carburetor *1
Fuel filter
Fuel
System
Piping
Fuel tank
Spark plugs
Ignition
Ignition
timing *1
Starter
motor *1
Starting
System Battery
Starter rope
Propeller
10
Lower
Gear oil
Unit
Water
pump *1
Bolt and Nuts
Sliding and Rotating Parts
Grease Nipples
Power Trim & Tilt *1
Oil Tank
Engine
Oil Oil Pipe
System *1
Oil Filter
Outer Equipment
Anode
*1 Have this handled by your dealer.
Servicing Interval
10 hours or 50 hours or
1 month 3 months
Action
Every 100
hours or 6
months
Strip, clean and adjust.
Adjust idling.
Check and clean.
Check and clean.
Clean
Check gaps.
Remove carbon
deposits.
Adjust timing.
Check for salt deposits
and battery cable
condition.
Installation, fluid
quantity, gravity
Check for wear or
damage.
Check for bend blades,
damage, wear.
Change or replenish-oil
and check for water
leaks.
Check for wear or
damage.
Retighten.
Apply and pump in
grease.
Check power unit oil
level and refill.
Check function of
manual release valve.
Check for leakage,
damage, position of
clips and filter
conditions
Check for corrosion.
Check for corrosion and
deformation.
Remarks
0.9-1.0 mm
(0.035-0.039 in)
Replace impeller
every 12 months.
Repair or consult your
dealer
Replace.