Lincoln FlowMaster A Serie Manual Del Usuario página 5

ELECTRIC FLOWMASTER PUMP
24 VDC, 5:1 gear ratio, 85567, 85568, 85591
BACK PRESSURE (PSI) RPM CURRENT DRAW (AMPS)*
0
1000
2000
3000
4000
5000
* A field installed fuse of 20 amps is recommended.
Table 2
ELECTRIC FLOWMASTER PUMP
24 VDC, 34:1 Gear Ratio, 2 Stage 85552 & 85553
Back Pressure (PSI) RPM Current Draw (AMPS)*
0
1000
2000
3000
4000
5000
* Fuse for 6 amps
Table 4
Illustration 2
A - Safety Unloader 272722 or 272572
B - 24 VDC from Controller
C- Outlet Shut-off Valve
D - Material Supply Line
E - Follower Plate (85492 for 120 lb.)
F - Drum Cover (84616 for 120 lbs.)
G - Field Installed Fuse
Form 403693
FlowMaster™ Rotary Driven Electric Pump
375 2
350 4.5
325 7.3
300 9.6
280 12
250 15.3
58.2 1.16
57.6 1.57
57.0 2.10
56.5 2.62
55.9 3.20
55.4 4.20
ELECTRIC FLOWMASTER PUMP
24 VDC, 17.8:1, gear ratio, 2-stage 85569
BACK PRESSURE (PSI) RPM CURRENT DRAW (AMPS)*
0 107
1000 105
2000 103
2500 100
* A field installed fuse of 5 amps is recommended.
ELECTRIC FLOWMASTER PUMP
24 VDC 19:1 Gear Ratio, 2 Stage, 85554 & 85566
Back Pressure (PSI) RPM
0 105
1000 103
2000 101
3000 99
4000 98
5000 96
* Fuse for 10 amps
Table 5
Operation
All pumps are set to run at full speed. Do not change the
settings for the pump until after the start up procedure.
1. Remove the pump outlet line.
2. With the pump in a full container of lubricant, energize the
pump. Make sure all air has been expelled from the pump
and even lubricant flow is achieved.
3. Reattach the pump outlet line. Never allow the pump to run
dry of lubricant. Monitor the supply lubricant level and refill
when necessary.
1.28
2
2.75
3.2
Table 3
Current Draw (AMPS)*
1.28
2.03
2.96
3.68
4.83
6.47
Page Number - 5