Distribution Of Chemical Products - GASPARDO ORIETTA OLIMPIA Instrucciones De Uso

Tabla de contenido

Publicidad

ENGLISH
3.16 ISTRIBUTION OF CHEMICAL PRODUCTS
Fertilizers and insecticides are distrib-uted by means of special
dosers (1, Fig. 50) fitted under the corre-sponding hoppers. These
dosers can be adjusted by turning the knob (2, Fig. 50). Depending
on how the dosers are regulated please refer to the tables below
you can determine the quantity of fertilizer and insecticide needed
to cover a hectare of land.
HOPPER AND TANK FILLING
Hoppers and tanks can be filled by hand or using a lifter with a
capacity of at least 200 kg, which must be regularly approved by
the relative authorities. Remember that weights of more than 25
kg must either be lifted by more than one operator or the above-
mentioned lifter must be used following the instructions included
in the relative use and maintenance manual.
- All fertilizer spreader tank loading and unloading operations
must be carried out with the planting unit at a standstill, on
the ground, with the frame open, with the hand brake on, with
the motor switched off and the starter key removed from the
control panel. Make sure that chemicals are kept out of
harm's way.
- All operations must be carried out by trained staff wearing
suitable protection (overalls, gloves, boots, masks etc) in a
clean, dust-free environment.
- Do not place any bags of fertilizer or any other object on the
fertilizer distributor container covers to avoid breaking them
or endangering property or persons.
- Load from the outer sides of the machine.
- When filling the seed, fertilizer and insecticide hoppers,
ensure that no foreign bodies (string, paper, etc.) enter them.
- The seeding machine can transport chemical substances.
Do not allow children, people, pets to come near the seeding
machine.
CAPACITY OF HOPPERS
Serbatoio
Materiale
(mm)
Metallo Plastica
850
A
1100
250
B
250
A - Spandiconcime; B - Microcranulatore; (*) - Solo con serbatoi in metallo.
The plastic distributors do not require lubrication. On completion
of the work, the hopper should be carefully cleaned. This
particularly applies to the fertilizer hoppers. Unscrew the
discharge pipe caps remove any residual product (Fig. 51) and
wash thoroughly with water. Adhere to the ecological standards
applicable for the disposal of polluting liquids.
3.16.1REGULATING THE FERTILIZER INTERRING HOE
The fertilizer interring hoes operate parallel to the row being sown,
at a standard distance.
Before utilizing the seeder, ensure that this distance is suitable
for the type of fertilizer to be distributed and the quantity to be
distributed per hectare, so as to ensure that the crops will not
be damaged.
Should the distance not be suitable, distance the hoes further
from the row being sown.
IMPORTANT! Minimum interrow distance recommended 30 cm.
Also regulate the depth at which the fertilizer is interred, by
changing the height of the spring (Fig. 52). After completing this
operation, cut any extra off the length of the tube so as to prevent
the creation of folds which could obstruct the flow of the fertilizer
(Fig. 52-53).
72
WARNING
Capacit
Rialzo
Top
(Litri)
(Litri)
(Litri)
157
203
15
16
USE AND MAINTENANCE
fig. 50
2
fig. 51
NR - 19
fig. 52
fig. 53
g
1
cod. 19702401
cod. G19502812

Publicidad

Tabla de contenido
loading

Tabla de contenido