Connecting A Usb Keyboard And Mouse; Developer Information; Controlling Ultimatte Using Telnet - Blackmagic Design Ultimatte 12 Manual De Instrucciones

10 Tap 'finish' to complete the installation and 'yes' to restart your Smart Remote 4.
Your Smart Remote 4 will restart and automatically launch the latest version of the
Ultimatte Smart Remote 4 control panel.

Connecting a USB Keyboard and Mouse

If you want to control your Ultimatte Smart Remote 4 using a keyboard and a mouse, simply plug
them into the USB ports on the rear panel. Your Smart Remote 4 will automatically detect the
keyboard and mouse as a plug and play device and you can control your Smart Remote 4 as if
using a Windows PC.

Developer Information

Controlling Ultimatte using Telnet

The Blackmagic Ultimatte 12 Ethernet Protocol gives you the freedom to build your own custom
control solutions for your Ultimatte 12. For example, you can create your own software
application and control your Ultimatte 12 via Ethernet from your computer.
The first step is to connect your Ultimatte to your computer via Ethernet. You can do this by
connecting Ultimatte to the same network your computer is connected to, or you can connect
Ultimatte directly to your computer.
NOTE If Ultimatte 12 is connected directly to your computer, set your computer to a
manual static IP address. Set the first three blocks of numbers in the IP address
to match your Ultimatte 12 and set the subnet mask to 255.255.255.0. You can leave
the gateway or router setting blank as it will not be used in a direct connection between
your computer and Ultimatte 12.
Developer Information 53