DJO ARTROMOT-E2 Instrucciones De Uso página 76

n Pronation/supination therapy
documentation
This is a special function of the
ARTROMOT®-E2/-E2 compact which
allows the entire therapy documenta-
tion to be represented.
The carriage run times as well as the
range of motion of the sessions are
recorded.
The collected data are presented graphi -
cally in the form of a coordinate system
(X-axis = range of motion / Y-axis = time)
where the upper curve illustrates the
trend of the supination movement and
the lower curve the trend of the pronation
movement.
LEVEL 5:
n Stretching in extension
With the special "stretching in extension"
function the joint will be gently stretched
(arm stretching movement). Only the
extension/flexion movement is treated
here. Motor B is automatically disabled.
The position of motor B cannot be
changed once this special function has
been activated.
Starting at the middle position the car-
riage will first move to the programmed
flexion limit and then to the programmed
extension limit.
Subsequently the carriage reverses 5 ° to-
wards flexion and then moves very slowly
back to the programmed extension value
(symbol: ). Subsequently the carriage
attempts to attain another 5 ° at an even
slower speed (symbol:
If a high resistance toward the additional
5 ° is sensed, the reverse on load function
is automatically activated and the carriage
moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed flexion limit and restarts
the stretching in extension cycle.
This sequence can be repeated as often
as needed. You can stop treatment with
the STOP key; after the programmed
therapy duration, it will stop automati -
cally.
Default: disabled
n Stretching in flexion
).
71
Note!
• If a pause has been programmed, the
carriage will stop for the pause each
time the maximum stretching value is
attained.
• Enabling the stretching in extension
function automatically disables motor
B. The only movement performed is
extension/flexion.
• It is not possible to combine a second
stretching function with the special
function "stretching in extension".
• During operation, the display will
show the symbol
left-hand corner.
With the special "stretching in flexion"
function the joint will be gently stretched
(arm bending movement). Only the
extension/flexion movement is treated
here. Motor B is automatically disabled.
The position of motor B cannot be
changed once this special function has
been activated.
Starting at the middle position the car-
riage will first move to the programmed
extension limit and then to the pro-
grammed flexion limit.
Subsequently the carriage reverses 5 °
towards extension and then moves very
slowly back to the programmed flexion
value (symbol: ). Then the carriage
attempts to attain another 5 ° at an
even slower speed (symbol:
If a high resistance toward the additional
5 ° is sensed, the reverse on load function
is automatically activated and the car-
riage moves in the opposite direction.
This stretch cycle is repeated ten times.
After that the carriage moves to the
programmed extension limit and re-
starts the stretching in flexion cycle.
This sequence can be repeated as often as
needed. You can stop treatment with the
STOP key; after the programmed therapy
duration, it will stop automati cally.
Default: disabled
Note!
The percentage values can be modified
only when the special function is enabled
(check mark).
in the upper,
).