Programming The Artromot; E2/-E2 Compact - DJO ARTROMOT-E2 Instrucciones De Uso

– For a uniform, smooth and gentle
transition between the two directions
of motion, the speed is automatically
reduced before reaching the reversal
point and, on reaching the reversal
point, it is continuously increased until
it reaches the set speed.
Patients with a
programmed chip card
• First complete the mechanical
adjustments.
• Then insert the chip card (the patient is
not yet positioned on the CPM device).
• Press the START key: the device will
move to the starting position as speci-
fied by the parameters stored on the
chip card and stops.
• Position the patient on the CPM device
and press the START key to initiate
therapy.
5.2 Programming the
ARTROMOT -E2/-E2
®
compact
Different programming levels are provided to
program the ARTROMOT
You change between levels by pressing the
MENU key repeatedly.
The currently selected level is indicated on
the display.
The following treatment values, settings
and information can be entered/viewed
on the programming unit (15):
LEVEL 1:
− extension
− flexion
− pronation
− supination
LEVEL 2:
− pause
− therapy timer

-E2/-E2 compact.

®
66
− speed
− warm-up protocol
LEVEL 3:
− reverse on load - motor A
− reverse on load - motor B
− motor A ON/OFF
− motor B ON/OFF
LEVEL 4:
− isolation protocol
− total therapy time
− therapy documentation:
extension/flexion
− Ttherapy documentation:
pronation/supination
LEVEL 5:
− stretching in extension
− stretching in flexion
− stretching in pronation
− stretching in supination
LEVEL 6:
− EROM repeat
extension/ pronation
− EROM repeat
flexion/supination
LEVEL 7:
− transport setting
− new patient
− operating mode
synchronized/
non-synchronized
− Service menu