Fuse Replacement; Transport - DJO ARTROMOT-E2 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 138

Fuse replacement

Warning!
m
Patient hazard, equipment malfunction
and damage
The replacement of fuses must be referred
to specialists as defined in IEC 60364
or other applicable standards (e.g. bio -
medical technicians, electricians, elec-
tronics installers).
Fuses used must be
S# < 20.000: T1A L250Vac
S# > 20.000: T2A H250Vac
fuses.
• Before replacing fuses, turn off the
ARTROMOT®-E2/-E2 compact and dis-
connect the device from the power line.
• Use an appropriate tool to remove the
fuse holder (8) situated between the
power switch (7) and the power connec-
tor (6) (Fig. 1).
• Replace the fuses and reinsert the fuse
holder (Fig. 2). Check that the fuser holder
locks properly into place.
Fig. 1
Fig. 2

6.3 Transport

6.3.1 ARTROMOT®-E2
The following operating steps must
be completed before transporting the
ARTROMOT®-E2:
1.
Activate the "transport setting" func-
tion
in the menu (see also 5.3)
and start the ARTROMOT®-E2.
2.
Turn off the ARTROMOT®-E2 power
switch (19).
3.
Remove the power cord (18) and dis-
connect the motion element (21) and
the programming unit (32).
4.
Open locking screw (4) and pull out
the armrest (14) for the healthy arm.
5.
Grasping the motion element at the
bracket (30) for adjustment of the po-
sitioning angle, open the locking screw
(4) and pull out the motion element.
6.
Set horizontal adduction/abduction to
0° (indexing knob 1).
7.
Open the locking screw for adjustment
of the backrest (10), fold the backrest
to the front all the way until flat on the
seat and tighten the screw.
8.
Remove the two locking pins (22). Pull
out the legs towards the sides, reverse
and reinsert. Then put the locking pins
back in place.
9.
Only use the original shipping box for
transporting the device. Ormed GmbH
cannot be held liable for transport
damage, if the device was not shipped
in its original shipping box.
10. Place the ARTROMOT®-E2 – legs first
– on the bottom of the box. The mark-
ings on the bottom of the box indicate
the correct position.
78

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Artromot-e2 compact

Tabla de contenido